Home> Technical Support > Other Pump > Technical Articles

WT3000-1FA Micro Gear Pump Flow Mode Operation

Release Time:2017-01-20

*Enter Flow Mode: Press Control Mode to enter next interface, press Up Key or Down Key to select Flowrate, press Confirm Key to save or press Return Key to cancel the setting and return to previous menu.

*Flow Setting:In Flowrate mode, press Up Key or Down Key to adjust the flow rates of pump. 
*Flow Calibration: 
     See below diagram, enter Calibration interface, press Up Key or Down Key to set the testing time, the range of testing range is from 30 to 1800 seconds, press Confirm Key to save the setting or press Return Key to cancel the setting and back to previous menu after select a certain testing time value. 
     The pump will display the running time and actual volume after pressing Start/Stop Key to start the calibration of pump. Running time will count down until testing time is over. Press Up Key or Down Key to input measured volume, press Confirm Key to save the setting. The calibration operation can be repeated. 

    If the actual volume is known in advance, enter the calibration interface and input the actual volume directly.