Home> Technical Support > Other Pump > Technical Articles

WT3000-1FB Micro Gear Pump Dispensing Mode Operation

Release Time:2017-01-20

*Enter Dispensing Mode: 
Press and turn the knob to highlight Control Mode line. Press Knob to enter next interface, turn Knob to select Dispensing, press Knob for confirmation. Press Exit Key not to store the selection and return to previous menu.

*Dispensing Volume: The volume to be dispensed between two time intervals.
   Press and turn Knob to highlight dispensing setting line. Press Knob to highlight dispensing volume line. Press Knob again to highlight the value of the volume. Turn Knob to select dispensing volume, press Knob for confirmation. Press Exit Key not to store the selection and return to previous menu.
   Change the dispensing volume, the dispensing time will change accordingly.

* Copy No.: the total filling number in dispensing mode. Its range is from 0 to 9999.
   Press and turn Knob to highlight copy number line. Press Knob to enter next interface. Turn Knob to select copy number, press Knob for confirmation. Press Exit Key not to store the selection and return to previous menu.
   If the copy no. is “0”, the dispensing process of the pump will continue until press Stop key or shut off the pump to stop dispensing.

Flow Rate Setting: the pump’s flow rates in dispensing mode. Adjusting the dispensing flow rates can change the dispensing time.
   Press and turn Knob to highlight dispensing flow rates line. Press Knob to enter next interface, turn Knob to select suitable flow rates, press Knob for confirmation. Press Exit Key not to store the selection and return to previous menu.

Pause Time: Time Interval between every dispensing operation. 
   Press and turn Knob to highlight pause time line. Press Knob to enter next interface. Turn Knob to select pause time, press Knob for confirmation. Press Exit Key not to store the selection and return to previous menu.

*Dispensing Calibration:
The parameters can not be changed under dispensing volume calibration operation. The defaulted parameters are the parameters set under Dispensing Setting.
   Pump stops under dispense mode, press and turn Knob to highlight calibration line. Press Knob to enter next interface. Turn Knob to select Dispensing. Press Knob to enter next interface.
   Press Run Key, the LCD displays running time and actual volume. Running time counts down.
   Turn Knob to input actual volume. Press Knob for confirmation.

   If the actual volume is known in advance, enter the calibration interface and input the actual volume directly.

*Dispensing mode operation procedure
网页聊天
live chat