Pump drive model

dPOFLEX GP02

dPOFLEX BP02

Housing material

Cast aluminum

304sst

Speed range

1rpm-300rpm, CW/CCW

Speed resolution

1rpm

Display

3.5 inch LCD, Chinese or English

Clock function

Clock can be set for log record, and displayed on the running screen

Work mode

Flow rate mode, dispensing mode, calibration mode

Flow rate mode

Pump runs continuously at the set flow rate, and displays flow rate and pump speed on the screen

Flow rate setting range

1.0ml/min-9.0L/min （depends on pump head and tubing）

Dispensing mode

Pump repeats the dispensing at set volume, cycles, interval time and back suction parameter, and displays single volume, total volume, dispensed cycles/target cycles on screen

Volume of single dispense

1.0mL-225L（depends on pump head and tubing）

Dispensing cycles

1-9999 and unlimited

Interval time

1s-9999s

Calibration function

Improve the flow rate and dispensing volume accuracy

Control mode

Keypad control, external signal control and communication control

Communication control

Interface: RS485, Profibus(optional)
Protocol: Modbus RTU, Profibus DP(optional)

Interface: RS485, Industrial Ethernet(optional) or Profibus(optional)
Protocol: Modbus RTU, Modbus TCP/IP(optional), Profibus DP (optional)

External control

Speed control signal: 0-5V, 0-10V, 0-10kHz, 4-20mA
Start/stop, direction control: 5V-24V logic level signal or relay signal (dry contact)

Status output

Running/stop, fault status: relay signal (dry contact)

Pump Speed: frequency signal
Running/stop, fault status: relay signal (dry contact)

Tubing compressed detection

The pump will automatically stop when detects the tubing is not compressed well, and an alarm message will be promoted. The function can be enabled and disabled.

Actual flow rate measurement

Measure and display the flow rate by connecting ultrasonic flow meter (optional)

Fluid pressure measurement

Measure and display the fluid pressure inside the tubing by connecting pressure sensor (optional)

Pump status when power on

Pump stops or runs in the flow rate mode. Pump stops in the dispensing mode

Keypad lock function

Enable the keypad lock function to lock the keypad automatically after 20s standby, (start/stop key will not be locked)

User access control

Three levels of user accesses (administrator, technician, operator)

Electronic signature and audit trail

Meet the requirement of FDA 21CFR Part 11

Log record

Record 90 days operation history, and can be exported directly

Support IQ/OQ

Meet GMP requirement

Certificate

CE, UKCA
EN 61010-1:2010，EN IEC 61010-2-201；EMC：EN IEC61000-6-2，EN IEC 61000-6-4

Dimension(LxWxH)

215 x 358 x 243mm (drive only)

215 x 362 x 258mm (drive only)

Power supply

AC100-240V/115W  50/60Hz

Operating condition

Temperature: 5℃-40℃, relative humidity≤100%

IP rating

IP66

Weight (drive only)

≤10.4kg

≤10.5kg

Product Model(Product Code)

Pump Head

Roller Number

Tubing

Reference Max. Flow Rate (L/min)

dPOFLEX GP02 (05.02.83A)
dPOFLEX BP02 (05.02.84A)

YZ35-13

3

26#

2

73#

4

82#

6.5

82#A

8

KZ35-13

3

26#

2

73#

4

82#

6.5

82A#

8

184#

9