Technical Support
- Peristaltic Pump ＞
- OEM Pump ＞
- Syringe Pump ＞
- Micro Piston Pump ＞
- Pump System ＞
- Other Pump ＞
Other Pump
Operating Video
How to Mount Micro Gear Pump Head
Tips
Communication Control Mode
Pump can provide RS485 communication module (see figure 1) to connect upper machine (computer, PLC, SCM).
Analog signal control mode
In external control mode, put ‘Internal Control/External Control’ switch to ‘External Control’ position. Connect external control module with pump according to pin defined as following.
Terminals of external control module are defined as following:
1#:: Common input end in 4-20mA, 0.5-5V and 1-10V external control module to control speed of pump.
2#:: Input end of start/stop of external control. Pump runs during open circuit or inputting low TTL; pump stops during inputting high TTL. (Start/Stop signal is opto-isolated input mode)
3#: not available
4#: Common end of analog input in 4-20mA, 0.5-5V and 1-10V external control module to control speed of pump.
5#: Common end of input signal in 4-20mA, 0.5-5V and 1-10V external control module; common end of frequency input in 1-10kHz external control module.
Other tips
-
How to use External Control Function for WT3000-1JB
2017-01-20 -
How to use External Control Function for WT3000-1JA
2017-01-20 -
How to use Footswitch Control for WT3000-1FB
2017-01-20 -
How to use External Control for WT3000-1FB
2017-01-20 -
WT3000-1FB Micro Gear Pump Dispensing Mode Operation
2017-01-20 -
WT3000-1FB Micro Gear Pump Flow Mode Operation
2017-01-20 -
How to use Footswitch for WT3000-1FA
2017-01-20 -
How to use External Control for WT3000-1FA
2017-01-20 -
WT3000-1FA Micro Gear Pump Flow Mode Operation Procedure
2017-01-20 -
WT3000-1FA Micro Gear Pump Flow Mode Operation
2017-01-20
