Technical Support
- Peristaltic Pump ＞
- OEM Pump ＞
- Syringe Pump ＞
- Micro Piston Pump ＞
- Pump System ＞
- Other Pump ＞
WT3000-1FA Micro Gear Pump Flow Mode Operation Procedure
Release Time：2017-01-20
Dispensing Mode Operation
Note: It is recommended installing a one-way valve to prevent liquid reflux which will affect the accuracy of dispensing volume before starting dispensing mode.
*Enter Dispensing Mode: Press Confirm Key to enter Control Mode interface, press Up Key or Down Key to select work mode, press Confirm Key to save the setting or press Return Key to cancel the setting and return to previous interface.
*Dispensing Volume: The volume to be dispensed between two time intervals.
Enter Dispensing Setting interface, press Up Key or Down Key to set dispensing volume, press Confirm Key to save the setting or press Return Key to cancel the setting and return to previous interface.
Running time will be changed corresponding to the changing of dispensing volume.
*Copy No.: The dispensing times are from 0 to 9999 times in Dispensing work mode.
Enter Dispensing interface, press Up Key or Down Key to set the copy number, press Confirm Key to save the setting or press Return Key to cancel the setting and back to previous interface.
If set Copy Number to Zero, dispensing cycles will be an infinite loop approach to work
*Flow Setting: The flow rates mean the flow rates in dispensing mode, the running time will be changed when adjusting the flow rates.
Enter Flow rates interface, press Up Key or Down Key to set the flow rates, press Confirm Key to save the setting or press Return Key to cancel the setting and back to previous interface.
*Pause Time: The Pause time between two dispensing cycles.
Enter Pause Time interface, press Up Key or Down Key to set the pause time, press Confirm Key to save the setting or press Return Key to cancel the setting and back to the previous interface.
*Dispensing Calibration: The parameters can not be changed under dispensing calibration, the default parameters are the parameters of dispensing mode.
Enter Dispensing Calibration interface.
Press Start/Stop Key to start the Calibration, and then enter next interface to display the Running Time and Measured Volume, the running time will count down until the calibration is over.
If the measured volume is known in advance, user can input the measured volume directly using Up Key and Down Key in calibration interface. It is unnecessary to repeat above steps.
*Dispensing Mode Operation Procedure
