Technical Support
- Peristaltic Pump ＞
- OEM Pump ＞
- Syringe Pump ＞
- Micro Piston Pump ＞
- Pump System ＞
- Other Pump ＞
Syringe Pump TJP-3A Work Mode Selection
Release Time：2017-09-08
infusion mode, infusion/withdraw mode, withdraw/infusion mode, program
mode.
Infusion mode: pump infuses according to programmed parameters.
The pump will automatically stop when pump infuses target volume.
Withdraw mode: pump withdraws according to programmed parameters.
The pump will automatically stop when pump withdraws target volume.
Infusion/Withdraw mode: first, pump infuses according to programmed
parameters, the pump pauses when pump infuses target volume, the
interval time is programmed pausing time; after pausing time, pump
withdraws according to programmed parameters, the pump will
automatically stop when pump withdraws target volume.
Withdraw/infusion mode: first, pump withdraws according to
programmed parameters, the pump pauses when pump withdraws
target volume, the interval time is programmed pausing time; after
pausing time, pump infuses according to programmed parameters, the
pump will automatically stop when pump infuses target volume.
Program mode: In program mode, every step can set different scheme,
and combine multi-step to accomplish a complicated work process.
There are software simulation modules in testing software which can
simulate the parameters of each step into figure. Operator will be easy
to check if there are any wrongs with inputted parameters. Refer to
“Testing Software Instruction” to know more details.
In work mode and stop state, press RCS to enter menu setting interface,
turn RCS to highlight “model”, press RCS to next interface. Turn RCS to
choose program mode, press to save the setting or press Exit Key to
cancel the setting.
Setting example is shown as below:
