Technical Support
- Peristaltic Pump ＞
- OEM Pump ＞
- Syringe Pump ＞
- Micro Piston Pump ＞
- Pump System ＞
- Other Pump ＞
BT100-1F Dispensing Volume Calibration
Release Time：2016-12-16
The parameters can not be changed under dispensing volume calibration operation. The defaulted parameters are the parameters set under Dispensing Setting.
1. Pump stops under dispense mode, press and turn Knob to highlight calibration line. Press Knob to enter next interface.
2. Press Start/Stop Key, the LCD displays running time and actual volume. Running time counts down.
3. Turn Knob to input actual tested volume. Press Knob to confirm.
If the actual volume is known in advance, enter the calibration interface and input the actual volume directly.
1. Pump stops under dispense mode, press and turn Knob to highlight calibration line. Press Knob to enter next interface.
2. Press Start/Stop Key, the LCD displays running time and actual volume. Running time counts down.
3. Turn Knob to input actual tested volume. Press Knob to confirm.
If the actual volume is known in advance, enter the calibration interface and input the actual volume directly.
