Technical Articles

• Mounting the MSP1-D1

  09/28/2017

  MSP1-D1 contains mounting holes in the top right and bottom left corners of the pump face. It is designed to mount to a panel using two M3 socket head cap screws. Shown as Figure 2-9

• MSP1-D1 Industries Syringe Pump Installing Components

  09/28/2017

  See Chapter 5, "Maintenance," for the procedures for replacing and maintaining components. Below installing instruction is for the 3- ports valve

• MSP1-D1 Printed Circuit Board Setting and Options

  09/28/2017

  DIP dial switch is used to configure different work modes, see Figure 2-4,shown DIP dial switch and status. Figure 2-4 DIP Dial Switch

• MSP1-D1 Industries Syringe Pump Hardware Setup

  09/28/2017

  The MSP1-D1 requires a 24VDC power supply with a current rating of at least 500mA, provided through a DB-15 connector. LongerPump recommends using one power cable for every two pumps to provide noise ...

• MSP1-D1 Industries Syringe Pump Functions

  09/28/2017

  MSP1-D1 uses a stepper-motor driven syringe and valve design to aspirate and dispense measured quantities of liquid. Both the syringe and the valve are replaceable. The illustrations below show the MS...

• Syringe Pump TJP-3A Communication

  09/08/2017

  Operator needs to set address and baud rate of controller when remotely controlling the pump by communication. The address range is from 1 to 30, there are three kinds of baud rates are optional, whic...

• Syringe Pump TJP-3A Running Parameters Setting

  09/08/2017

  Different work mode is corresponding to different running parameters. Now divide five kinds of work modes into two categories: common mode and program mode. Common mode includes withdraw, infusion, in...

• Syringe Pump TJP-3A Work Mode Selection

  09/08/2017

  There are five kinds of woke modes available, which are withdraw mode,infusion mode, infusion/withdraw mode, withdraw/infusion mode, program mode.

• Syringe Pump TJP-3A Setting & Selection of User-Define Syringe

  09/08/2017

  In work mode and stop state, press RSC to enter to menu setting interface, turn RCS to highlight “Syringe”, press RCS to enter next interface. Turn RCS to highlight “User Define”, press RCS to ent...

• Syringe Pump TJP-3A Standard Syringe Selection

  09/08/2017

  In work mode and stop mode, press RCS to enter menu setting interface, turn “RCS” to highlight “Syringe”, press RCS to enter next interface. Turn RCS to highlight “Manufacture”, press RCS to ent...

• Syringe Pump TJP-3A Language Selection

  09/08/2017

  Switch on the controller, the controller will display product type, display language options interface after 1 second delay. Language selection interface will keep 3 seconds. Turn RCS to select necess...

• Syringe Pump TJP-3A Software Operation

  09/08/2017

  Menu Navigation Vol : 2.000ml Flow: 12.00ml/m Time: 00:00:10 ■ → R0 C0 T2 Model: Infusion Syringe: 10ml Communication EXT.control: Infusion Withdraw I/W W/I Model:Infusion Communication EXT.control:...