Home> Technical Support > Syringe Pump > Technical Articles

Technical Articles

  • Programmable Syringe Pump TJP-3A Basic Function

    09/08/2017

    Operation panel consists of membrane and LCD display, shown as below: 3. Usage & OperationLCD Screen Fast Forward/Stop Key Start/Pause Key Fast Reverse Key Exit Key Rotary Coded Switch (abbr. RCS, her...

  • Programmable Syringe Pump TJP-3A System Installation

    09/08/2017

    This chapter includes: Installing syringe Connection of data cable and power cord Follow below steps to install syringe:

  • Programmable Syringe Pump TJP-3A System Structure

    09/08/2017

    This syringe pump consists of TJP-3A controller and W0109-1B driveunit, shown as below。 Power Switch: Control the start/stop of syringe power supply.Power Socket: DC12V power supply input interface.

  • Syringe Pump SP1-C1 Address Switch Setting

    07/28/2017

    Address switch (Figure 3-5) is located on lower of the pump back panel. It is used to set the unique address for each pump in the multi-pump system, allowing user to direct commands to specific pump. ...

  • Industrial Syringe Pump SP1-C1 DIP Dial Switch Setting

    07/28/2017

    DIP dial switch is used to set the different working modes and configurations. Refer to Figure 3-4 for the DIP dial switch setting and the corresponding working mode and configuration

  • Industrial Syringe Pump SP1-C1 Control Board

    07/28/2017

    The control board, used to control the syringe plunger and valve, includes microprocessor and circuitry. The external interfaces of control board include DIP dial switch for operating model selection,...

  • Industrial Syringe Pump SP1-C1 Valve

    07/28/2017

    The valve is made of a Kel-F body and Teflon plug. The plug rotates inside the valve body to connect the syringe port to the various input and output ports. The valve is driven by step motor and the e...

  • Industrial Syringe Pump SP1-C1 Syringe and Syringe Drive

    07/28/2017

    The syringe plunger is held to the plunger holder which is also connected to the ball screw drive. The ball screw drive is incorporated with step motor. Then the plunger moved within the syringe barre...

  • Industrial Syringe Pump SP1-C1 Function

    07/28/2017

    SP1-C1 uses step motor driven syringe and valve design to aspirate and dispense measured quantities of liquid. The syringe and valve are replaceable. The function and illustration of major components ...

  • LSP01-1C Syringe Pump External Control interface

    07/07/2017

    External Control Function: Input/output control - Calibration Function: Acquire accurate volume through calibration - Syringe Protection: Adjust syringe rest to prevent syringe from damaging

  • LSP01-1C Push & Pull Syringe Pump RS485 setup

    07/07/2017

    Communication Function: Realize computer control through RS485 communication interface - External Control Function: Input/output control

  • LSP01-1C Push & Pull Syringe Pump calibration

    07/07/2017

    LSP01-1C is a push-pull simultaneous infusion/withdrawal pump. The acceptable syringe specification is from 10μL to 10mL.