Home> Technical Support > Syringe Pump > Technical Articles

Technical Support

LSP02(10)-1B Dual Channels Syringe Pump Volume setting

Release Time：2017-01-06

In parameters setting interface, turn and press RES to highlight the infusion volume or withdrawal volume setting line. Press RES to make the numerical value position highlighted. Enter targeted volume from the membrane keypad. Press RES to set volume unit. Turn RES to scroll through the list and press RES to select the unit required. Possible volume units are µl and ml, i.e. microliter and milliliter. The highlighted display indicates that this parameter can be changed. 

Note:
When the volume setting is zero, 
  •    Infusion or Withdrawal modes.
Volume = 0 is interpreted as no volume and the pump will run until manually stopped or a stall occurs. The LCD will display the flowrate setting.
  •    Infusion/withdrawal, Withdrawal/infusion and Continuous modes. 
A volume setting must be entered. If no volume is entered the motor does not run.


Prev：LSP02(10)-1B Dual Channels Syringe Pump Flowrate setting Next：LSP01(04)-1A Syringe Pump Calibration