Technical Articles

• YZ1515x，YZ2515x pump head Operating Instruction

  03/17/2017

  YZ1515x，YZ2515x pump head Operating Instruction.Change tubing easily and rapidly; Automatic tubing retention; Suitable for several tubing sizes; The rollers adopt high quality materials and has good ...

• BQ50-1J Operation panel of the Hand-held Remote Controller

  02/24/2017

  BQ50-1J Operation panel of the Hand-held Remote Controller。Miniature Peristaltic Pump BQ50-1J has small flow rate and compact size, which can be mounted on your equipment rack or panel. The pump prov...

• Miniature Peristaltic Pump BQ50-1J Introduction

  02/24/2017

  Miniature Peristaltic Pump BQ50-1J Introduction.Miniature Peristaltic Pump BQ50-1J has small flow rate and compact size, which can be mounted on your equipment rack or panel. The pump provides flow ra...

• How to use External Control for YT600-1J

  01/06/2017

  There are three external control modes; customer can select one control mode only. 1.4-20 mA standard current input 2.0-10 V standard voltage input 3.0-10 kHz pulse input

• WT600-4F - Industrial Peristaltic Pump Dispensing Calibration

  12/30/2016

  All the parameters can not be revised under dispensing calibration mode, the default parameters are these parameters under dispensing mode. Follow the below diagram, enter ‘Calibration’ interface.

• WT600-4F Flow Mode Operation

  12/30/2016

  *Enter Flowrate Mode：Follow below diagram, enter ‘Control Mode’ interface, press ‘Increment Key’ or ‘Decrement Key’ to highlight ‘Flowrate’ , press ‘Confirm Key’ to save the setting or pre...

• WT600-4F Pump Head & Tubing Selection

  12/30/2016

  *Pump Head Selection: Enter ‘Pump head & Tubing’ interface, press ‘Confirm Key’ to enter pump head selection interface, press ‘Increment Key’ or ‘ Decrement Key’ to select pump head, press ‘C...

• Industrial Peristaltic Pump WT600-4F Operation Menu Diagram

  12/30/2016

  Current Working Interface 1. System Setting 2. Control Mode 1.Pump head&Tube YZ35-13 82# 2. Ext Cont.: ON 3. Address: 1 4. Footswitch: G 5. Back Rev.: 0.0

• How to use Footswitch for WT600-3J

  12/30/2016

  Connect to external control interface to control the start/stop of the pump. The speed and direction of the pump are controlled by membrane keypad. Wiring diagram is shown as below: Short pin #4 and #...

• How to use External Control Function for WT600-3J

  12/30/2016

  The external control includes start/stop control, direction control and speed control (4 – 20mA, 0.5 – 5V, 1 – 10V or 1 – 10kHz). The start/stop of the pump can be controlled by footswitch or rela...

• How to use Footswitch Function for WT600-2J

  12/30/2016

  Connect Footswitch to External Control Port to control Start/Stop of pump. Note: Footswitch is optional accessories. It can only control the start and stop of the pump. The speed and direction of the ...

• How to use External Control Function for WT600-2J

  12/30/2016

  Communication Control：The pump can connect to control computer (computer, PLC, SCM) through RS485 serial communication module (shown as below).