Technical Articles

• How to use Back Suction for BT300-1F

  12/16/2016

  In dispensing and filling state, to prevent the liquids drippage to cause error when the filling stops, the pump will back-turn a back suction angle to suck back the liquids. The back suction is the s...

• BT300-1F - Dispensing Peristaltic Pump System Setting

  12/16/2016

  Enter “System Setting” interface. There are 7 submenus in “System Setting” menu. They are “Tubing ID”, “Remote Control”, “Pump I.D.”, “Footswitch”, “Back Suction”, “Time Setting” and ...

• BT300-1F Peristaltic Pump Filling and Dispensing Setting

  12/16/2016

  Enter “Fill Setting” interface: 1. Other parameters can’t be set here. Set the other parameters first and then go along the “Fill Setting”. Other parameters setting methods please see page 8 “Sy...

• Communication Function for BT100-1F

  12/16/2016

  BT100-1F can connect to the control computer (computer, PLC, SCM) through RS485 serial communication interface. Max. 30 pumps can be controlled by a control computer

• How to use External Control Model for BT100-1F

  12/16/2016

  External Control Input *Communication Control The pump can connect to control computer (computer, PLC, SCM) through RS485 serial communication module (shown as below).

• BT100-1F - Dispensing Peristaltic Pump Operation Procedure

  12/16/2016

  Select pump head and tubing refer to “Suitable Pump head, Tubing, Ref. Flow Rate” table before working. Thick wall tubing is preferred for longer service life.

• BT100-1F Dispensing Volume Calibration

  12/16/2016

  The parameters can not be changed under dispensing volume calibration operation. The defaulted parameters are the parameters set under Dispensing Setting

• BT100-1F Peristaltic Pump Calibration

  12/16/2016

  Pump should be calibrated when flow rate or dispense volume is beyond the tolerance. Flow rate and dispensing volume can be calibrated separately in different application.

• BT100-1F Peristaltic Pump Dispensing Setting

  12/16/2016

  Before dispensing process, the parameters including Pump Head, Tubing, Dispensing Volume, Copy number, Flow Rate and Pause time must be set. Dispensing Volume: the volume that the pump dispenses betwe...

• How to use Footswitch for BT100-1L

  12/09/2016

  Set footswitch working mode.1. Gated: The pump runs as long as the footswitch is pressed.2. Trigger: Press footswitch, the pump starts running; Press footswitch again, the pump stops.

• BT100-1L Peristaltic Pump Remote Control Function

  12/09/2016

  Communication Control:The pump can connect to control computer (computer, PLC, SCM)through RS485 serial communication interface (shown as below)

• BT100-1L Multi-channels Peristaltic Pump Flow Rates Calibration

  12/09/2016

  Calibration is needed in below situations:1. Use the pump the first time; 2. Change the tubing; 3. Change the pump head; 4. Set new flow rate; 5. Operate condition changes.