Technical Articles

• How to use External Control Function for BT100-2J

  12/09/2016

  Communication Control Analog Control Show as below for external control module. If you need external control function you just insert the external control module to the external control interface whic...

• Tygon A-60-F Peristaltic Pump Tubing for LongerPump

  11/29/2016

  ygon® A-60-F peristaltic pump tubing is ideal for use in clean-in-place and steam-in-place Peristaltic Pump BT100-2J, BT300-2J, BT100-1F, BT300-1F, etc. It is compatible with virtually all commercial...

• Terminal Definitionof Standard External Control Module

  11/28/2016

  Terminal Definitionof Standard External Control Module 1#N/A 2#External start/stop control input. When connectedto COM,the pump runs; When connected to high level (5 - 12V), the pumpstops. 3#External ...

• How to use External Control Function for BQ50-1J

  11/28/2016

  Analog Control External control module is shown as below. One side is DB15 connecting peristaltic pump. Another side is wiring terminal connecting control signal. When using external control function ...

• PharMed Tubing for Peristaltic Pump

  04/20/2016

  PharMed Tubing for Peristaltic Pump

• Longer New/Old Model Corresponding Table

  03/19/2016

  Longer New/Old Model Corresponding Table

• Pressure Conversion Table

  03/19/2016

  Pressure Conversion Table

• Longer Peristaltic Pumps Selection Sheet

  03/19/2016

  Longer Peristaltic Pumps Selection Sheet (Model, Pump Head, Tubing, Flowrates)

• Tubing testing guides

  12/19/2015

  Immersion test will be needed, when the chemical compatibility of the tubing is uncertain. In this test, weighed a small piece of tubing and measured its length and diameter. afterward immersed this t...

• Peristaltic pump selection guides

  12/19/2015

  A.Tubing selection Flow rate- Refer to flow rates curve Chemical compatibility-The tubing material must be compatible with the fluid. Fluid Temperature-Tubing applications are often restricted due to...

• Peristaltic Pump Head Flow Rates Curve

  12/19/2015

  Peristaltic Pump Head Flow Rates Curve

• Peristaltic Pump Tubing life Comparison

  12/19/2015

  The table blow depicts hours until failure of 1/4” I.D. × 3/8”O.D. tubing in each corresponding formulation. In each case, a 3-rollers pump head was utilized operating at 600 rpm under room tempera...